My truck:
 |
| 1975 Datsun 620 Truck |
 |
| 1975 Datsun 620 Truck |
 |
| 1975 Datsun 620 Truck |
The Ratsun Forums:
http://community.ratsun.net/
The 620 Link:
http://www.davidcmurphy.com/olddat/620tech.htm
Parts Manual:
http://www.carpartsmanual.com/datsun620/Datsun620Index.aspx
Some inspiration taken from these:
And I would like to use this as "white canvas" for colors considerations:
Color selection:
http://www.colorexplorer.com/colorpicker.aspx
These are some webpages that I would like to save for the future, since they could come in handy:
Headlight relay modification
Carburetor Information
How to connect a Carburator 1
Head bolts to get:
Part Number 11056-p7600 short bolt,
11059-p7600 long bolt
@ Nissan site
The 620Head Bolt Torque Sequence:
FRONT
ENGINE
7...8
3...4
1...2
5...6
9..10
First torque to 20 ft lbs, Second torque to 40 ft lbs, final torque to 60 ft lbs.
Replacing the Driveshaft Carrier Bearing:
According to a source online:
"The driveline carrier brg can be replaced without special tools. It only looks hard. In the worst case, you might need an impact wrench to remove the companion flange nut, and a std gear/jaw puller to pull the flange off the driveshaft, but the last one I did did not require either of those. You willneed the correct size socket for the companion flange nut. I don't recall its size; probably 27mm or 30mm, but that's only a guess.
Torque down bolts (center flange bolts and rear flange bolts) on driveshaft to 17-24 lb-ft.
Torque down carrier bearing bracket down to 12-16 lb-ft.
A direct fit for a water pump bolt set is available from the Z store as part number 14-1256.
Torque down driveshaft nut to 145-174 ft-lb
No comments:
Post a Comment